Investigation of transport phenomena in a hybrid ion exchange-electrodialysis system for the removal of copper ions

Hybrid ion exchange electrodialysis processes allow the removal of metal ions from dilute waste liquids and the recovery of more concentrated solutions. The work reported here was aimed at investigating the two steps in the treatment process, namely, adsorption of metal ions onto the packed bed of resin and electromigration (i.e., the transport of these ions in the complex system under the applied electrical field). The case of copper sulfate was investigated. Dowex resins with a cross-linking degree of 2 and 8% were used. The flux of copper through the resin bed and the current efficiency for ion transfer to the cathode compartment were determined as a function of potential gradient and copper ionic fraction in the bed. Apparent diffusion coefficients of Cu²⁺ in the overall system were deduced from the experimental data.     

Ni-ZrO2纳米复合电铸层抗高温氧化性能的研究

通过间歇式抗高温氧化实验,建立了纯镍电铸层和N i-ZrO2纳米复合电铸层高温氧化动力学模型,分析了电铸层表面和横截面的形貌,测定了电铸层的组织结构。结果表明,N i-ZrO2纳米复合电铸层抗高温氧化性能明显优于纯镍铸层,复合电铸层表面生成的氧化膜晶粒细小且致密,并且该氧化膜较薄,产生的内应力较小,与复合电铸层的黏附性较好。     

Effect of cobalt oxide on surface structure of alumina supported molybdena catalysts studied by in situ Raman spectroscopy

A set of Co promoted 10% Mo/Al₂O₃ samples have been characterized by means of Raman spectroscopy under ambient as well as in situ dehydrated conditions. Under ambient conditions, the degree of the polymerization of surface molybdenum oxide species decreases with increasing Co loading. Under dehydrated conditions, the polymeric molybdenum oxide species is absent with the addition of only 0.2% Co. At low Co loadings (2%), before the formation of CoMoO₄ compound, the spectral features are very similar under ambient conditions. Dehydration causes the upward shift of the Mo=O symmetric stretching mode. A broad band around 920–930 cm^–1 was thus observed. This band has been suggested to be associated with the Co-Mo interaction species. In contrast to crystalline CoMoO₄, this species shows a reversibility on H₂ reduction-O₂ reoxidation treatments. From the results obtained, it is proposed that cobalt oxide interacts with the most polymerized molybdenum oxide species to form Co-Mo interaction species and/or crystalline CoMoO₄; therefore, the amount of the surface molybdenum oxide species decreases with a change in the molecular structure as a function of the Co concentration.     

Production of nanoparticles of copper compounds by anodic dissolution of copper in organic solvents

The anodic behaviour of copper was investigated in ethanol solution containing LiClO₄, LiCl electrolyte and water. The type of electrolyte and the water content influences the mechanism of the anodic process and the formation of anodic products. In LiClO₄ electrolyte the dissolution of copper is related to the oxidation of Cu(I) to Cu(II). In solutions of LiCl the etching of copper begins with the creation of soluble complexes of Cu(I) with chloride ions and solvent molecules. At potentials above 0.4 V the formation of alkoxides was observed in both solutions, characterized by a yellow tint. On the other hand, above 0.8 V (i.e. above the equilibrium potential of alcohol oxidation) copper dissolution is accompanied by the formation of a blue colloidal suspension of Cu (II) copper salt. Anodic etching of copper in solutions containing 3% H₂O at potentials higher than 0.4 V leads to the formation of colloidal suspension of copper oxide nanoparticles.     

Strong dependence on pressure of the performance of a Co/SiO2 catalyst in Fischer–Tropsch slurry reactor synthesis

A 10 wt% Co/SiO₂ catalyst was prepared by the incipient wet-impregnation method and tested in Fischer–Tropsch synthesis in a slurry reactor under conditions approaching industrial practice. The catalyst precursor was investigated by X-ray diffraction (XRD), temperature-programmed reduction (TPR), transmission electron microscopy (TEM) and photoelectron spectroscopy (XPS). The XPS and XRD techniques revealed the presence of a crystalline Co₃O₄ spinel-type phase, while-in addition-TEM and XPS analyses pointed to the formation of another amorphous Co₃O₄ spinel phase, both species interacting weakly with the silica substrate. The influence of total pressure on the conversion, selectivity and stability of the catalyst was studied. Upon increasing the overall pressure from 20 to 40 bar, not only activity increased but also the catalyst are not deactivating. These results are explained in terms of an increase of gases solubility in the solvent, this increment of CO concentration in the liquid phase favours carbonyl species formation and the cobalt particles segregation that implies an increase in the metal surface area.     

表面活性剂(PVA)浓度对电子束制备纳米铜的影响

在水溶液中,常温常压下使用聚乙烯醇(PVA)为表面活性剂,用电子束辐照方法可以成功制备纳米铜粉。利用紫外可见分光光度计(UV)和激光粒度衍射仪(LSPSDA)考察了表面活性剂浓度对纳米铜粒径分布和团聚的影响。在一定范围内随着PVA浓度的增大纳米铜的粒径减小到13nm。X射线衍射(XRD)和透射电子显微镜(TEM)结果表明PVA浓度为0.88g/100mL,pH值在5~9之间时,能得到纯的纳米铜,其粒径分布为15~40nm。     

适用于摩托车零件的多层镍电镀工艺

概括目前我国摩托车零件电镀所用镀层组合，对照有关金属覆盖层的国家标准，认为摩托车零件应用多层镍组合，并提供了工艺配方。     

Reforming of methane with carbon dioxide over supported bimetallic catalysts containing Ni and noble metal: I. Characterization and activity of SiO2 supported Ni–Rh catalysts

Cobalt catalysts supported on silica aerogel have been prepared using sol–gel chemistry followed by drying under supercritical ethanol conditions. Three different loadings of cobalt were synthesized: 2, 6, and 10% by weight. Transmission electron micrographs indicate that the metallic cobalt exists as discrete particles 50–70 nm in diameter for the 2 and 6% loadings. The 10% catalyst shows long needles of cobalt. BET and BJH measurements indicate that the catalysts retain the silica aerogel properties of high surface area (∼800 m²/g), large pore volume (∼5 cm³/g), and an average pore diameter in the mesoporous regime (∼25 nm). The catalysts were evaluated for Fischer–Tropsch activity in a laboratory-scale packed bed reactor. All three catalysts were active with the 10% Co catalyst achieving more than 20% CO conversion which corresponds to a rate of 1.53 g CO per g-cat per hour. The catalysts were selective for the C₁₀₊ hydrocarbons with more than 50% of the carbon contained within this fraction. A significant portion of the C₉–C₁₅ hydrocarbon product was observed as 1-olefins which reflects the enhanced mass transport within the very porous aerogel support.     

Corrosion inhibition of copper in near neutral aqueous solutions by gamma-pyrodiphenone

The inhibition effect of gamma-pyrodiphenone (PD) on copper corrosion in near neutral sulphate solutions was investigated. Weight loss and polarization measurements show a high inhibition efficiency (>96%) of PD on copper corrosion at extremely low concentrations. PD suppresses active copper dissolution and oxygen reduction. The potentiodynamic cathodic reduction measurements showed an inhibition of oxide formation and stabilization of the Cu2O oxide in the presence of PD. XPS measurements suggested that the high inhibition effect of PD on copper corrosion is due to the adsorption of PD molecules, as a first stage, and the formation of a film with a polymer-like structure by coordination of PD with Cu2O on prolonged exposure.     

滴定分析法测定铜的改进

提出在ＮＨ４ＨＦ２介质中，有ＳＣＮˉ存在下，以Ｉˉ３—淀粉为指示剂，硫代硫酸钠滴定铜的分析方法